Alesis 2 User Manual page 48
Micro series
Hide thumbs
Also See for 2:
- Reference manual (103 pages) ,
- Setting up (12 pages) ,
- Instruction manual (6 pages)
Advertisement
MICRO ENHANCER@,O't,A
LED s, determines the slope, or the way the MICRO ENHANCER
willwork on high and mid frequencies.
The Mix control determines how much high frequency information
is added to the signal going through the unit.
The Bandwidth control determines how much treble or mid-range
i s a d d e d t o t h e s i g n a l . W i t h t h e B a n d w i d t h c o n t r o l
counterclockwise (all the way to the left), only the very high
frequencies are added; with the Bandwidth control at maximum
(all the way to the right) upper and lower midrange frequencies
are added as well.
A n I n / O u t s w i t c h a l l o w s t h e u s e r t o b y p a s s t h e M I C R O
ENHANCER for comparison purposes, if so desired.
Operation
After connecting your MICRO ENHANCER (refer to the section
on installation), begin by turning the Threshold control to the right
(clockwise) until the red LED lights. Make sure that the In/Out
switch has been pressed to the "in" position or the LED s will not
fire. This unit's LED s are not your typical input level indicators,
but indicate the slope, or the way the MICRO ENHANCER will
work on high and mid frequencies. This means that the sound will
differ if the threshold is set so that the first green LED is lit from
the sound when the red LED is lit. This is due to the fact that more
high frequency energy is triggered as more LED s are triggered
(the slope is altered). See tigure 27N278
FIGURE 27A
FIGURE 278
I
)
uJ
uJ
I
tr
E
BANDWIDTH Control Full Left
BANDWIDTH Control Full Rioht
FREQUENCY
45
Advertisement
Need help?
Do you have a question about the 2 and is the answer not in the manual?