Table of Contents
Advertisement
beginning of each tape.
4.1B Locate 0
Press this button to have all slave ADATs rewind or fast forward to
the 0 point location. Remember, this can be anywhere on the tape
since pressing the RESET 0 button resets the tape counter to 00:00
(see section 4.1A). The REW or FFW LED will flash depending on
the direction of the search.
• If the LOCATE 0 button is pressed while in record mode, recording
will be stopped (punched out) before performing the locate.
4.1C Setting a Locate Point
The SET LOCATE button may be pressed at any time to store the
current tape location into memory for later recall. This tape position
is referred to as the locate point's address.
To set a locate point:
1. Press the SET LOCATE button, and the current tape location will
be stored as a new locate point;
The display will show the following:
L X X "LocNamXX"
...where XX is the locate number (1 through 20), LocNamXX is an 8-
character name and hh:mm:ss:ff is the current tape address. The
address is displayed according to the type of Display Type you have
selected. If in NORMAL mode, the display will read 00:00:00
(minutes:seconds:frames) and the frames will default to 30 frames per
second. If in SMPTE mode, the display will read 00:00:00:00
(hours:minutes:seconds:frames); if in BARS mode, the display will
read 01–01/00 (bars:beats:sub-beats).
The locate number defaults to the last locate point displayed +1, and
is automatically stored. The first time SET LOCATE is pressed (if the
Locate button has not yet been pressed), the locate point number in
the display will be 01. If locate point number 5 is currently being
displayed, then pressing SET LOCATE will advance the display to
locate point number 6 and store the current tape position there. If
locate point number 20 is being displayed, pressing the SET LOCATE
button will not advance the display, thus the current tape position is
hh:mm:ss:ff
35
- Quick Links:
- Chapter 2: Hookup
- MIDI In/Out
- C External Sync
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the BRC and is the answer not in the manual?