Table of Contents
Advertisement
4
A Tour of the GRIP
GAIN REDUCTION LED Meter
The red LED meter displays the amount of gain reduction
applied by the bass limiters. An increase in gain reduction –
by turning the BASS DRIVE Knob clockwise - will cause
the meter to light from right to left.
BASS LEVEL Knob
This knob adjusts the level of the frequencies that fall
below the crossover point set by the XOVER knob, except
for the sub-bass.
BASS LEVEL LED Meter
This meter indicates the level of the GRIP's main output
signal. As you increase the level by turning the BASS
LEVEL knob clockwise, this meter lights amber from left
to right.
LO CUT Knob
This adjusts the cutoff frequency of a steep (6-pole) high-
pass filter, effectively limiting the lowest frequencies that the
GRIP can output. The unit will output only those
frequencies that are higher than the one set with the LO
CUT knob. This knob is useful for protecting your speakers
from ultra-low frequencies that may cause damage.
OUTPUT Knob
This knob controls the level of the GRIP's total output
signal from both the bass and sub-bass channels.
BYPASS Button
When you activate this button, the audio signal bypasses the
Grip without being processed. This is useful when you want
to compare the processed signal with the unprocessed signal.
This button lights red when you enter BYPASS mode.
21
Advertisement
Table of Contents
Need help?
Do you have a question about the GRIP Legacy Series Audio Processor Synthesizer and is the answer not in the manual?